QuickBooks Error H202: Here Are the Right Ways to Fix It

• Improper firewall or internet security settings can block QB from accessing the company file stored on the server
• If company file hosting is enabled on the workstation instead of only on the server
• The error can also occur if the server’s IP address is not properly set up in QBDT on all workstations or if the workstation IPs are missing on the server
• In some cases, the server device may ot have the required Windows administrator privileges to perform certain QB operations
• A failed or unstable connection between the server and the workstation can also prevent access to company files in multi-user mode
• A Windows task may be interrupted either by a malfunctioning firewall or the blocking of QB from running on the network

To remove the error code H202 from your device, you need to follow the steps mentioned below:

• Open the Network Issues section in the QuickBooks Tool Hub > from there, select QuickBooks Database Server Manager
• If QuickBooks is not installed on your server computer, you’ll be prompted to install it before proceeding
• In the QBDSM window, click Start Scan if your company file folders are already visible
• If they aren’t listed, select Browse to find the company file, then tap Start Scan. The Database Server Manager wil automatically adjust your Windows Firewall settings during the scan
• As the procedure is finished, click Close > open QBDT on each workstation where you are seeing error H202
• Move to the File tab > click Switch to Multi-User Mode
• If your server device is also used as a aworksatton make sure to perform this step there as well

Read Also: How Do I Fix QuickBooks Error 12007?

• Go to your server device > click the Windows key to open the Start menu
• In the search box, type Run > click Enter. When the Run window opens, type services.msc and press Enter again
• From the list of services, locate QuickBooksDBXX and double click it to openthe Properties window
• Under the General tab, set the Startup type to Automatic
• Next, check the service statu it should show Running or Started. If it isn’t, click Start
• Now, switch to the Recovery tab
• For First Failure, Second Failure, and Subsequent Failures, choose Restart the Service from the drop-down menus. Click Apply, then OK to save the changes
• Fianlly after completing the procedure, repeat the same process for QBCFMonitorService